Georgia Fiero Club Forum

All Things Fiero => General Fiero Discussion => Topic started by: GTRS Fiero on September 17, 2017, 01:17:08 pm

Title: Lug nut/lock fitment
Post by: GTRS Fiero on September 17, 2017, 01:17:08 pm

I have a set of locking lug nuts from a previous Fiero.  I'm not sure which Fiero, but it wasn't an '88.  Will these fit my '88?

These were never installed on a Fiero while I owned the Fiero.  I got 18 of them in a plastic bag, along with other things, like an old MAP sensor, lots of screws, several plastic lug nut covers, some brand new (but out of box) split-fire platinum spark plugs, an oil pressure sending unit, 2 O2 sensors, a used oil drain plug, and $.35.

Title: Re: Lug nut/lock fitment
Post by: Roger on September 17, 2017, 04:38:35 pm

Use the attached form for your locking lugs. Yours will fit any Fiero. These folks supplied all factory equipped Fieros' locking lugs. You will need the VIN.