Georgia Fiero Club Forum

All Things Fiero => The Market => Topic started by: GTRS Fiero on September 15, 2019, 08:06:11 am

Title: WTB: Heat shield by temp sensor
Post by: GTRS Fiero on September 15, 2019, 08:06:11 am

As the title states, I'm looking for the heat shield that protects the temp gauge sensor.  I'm not sure how to fit it in, though.

Title: Re: WTB: Heat shield by temp sensor
Post by: Fierofool on September 15, 2019, 09:08:30 am

Title: Re: WTB: Heat shield by temp sensor
Post by: GTRS Fiero on September 15, 2019, 09:19:31 am

Ah.  My coil packs are there, though.

Title: Re: WTB: Heat shield by temp sensor
Post by: Fierofool on September 15, 2019, 02:44:27 pm

Wouldn't that be detrimental to the ICM on the bottom of the coil pack, being that close to the exhaust?  That shield bolts where the base of the original coil bolted. 

Title: Re: WTB: Heat shield by temp sensor
Post by: GTRS Fiero on September 15, 2019, 02:47:58 pm

Well, the coil pack being mounted on the trunk wall did not work well.  Part of the issue was grounding, and part of the issue was the cheap ICM.

Title: Re: WTB: Heat shield by temp sensor
Post by: Fierofool on September 16, 2019, 11:13:22 am

Michael, the coil/ICM/sensor shield is in two pieces.  There are two small screws that attach the flat base plate to the upright coil/ICM deflector shield.  The upright can be removed, leaving the sensor shield and it's base attached to the mount that you probably have your coil pack mounted on.  I have a complete deflector and shield if you can't find just the sensor shield. 

Title: Re: WTB: Heat shield by temp sensor
Post by: GTRS Fiero on September 16, 2019, 06:30:54 pm

I'm going to see what I can come up with.