Georgia Fiero Club Forum
All Things Fiero => General Fiero Discussion => Topic started by: 88_4mula on February 11, 2010, 04:27:08 pm
-
I found an article on-line "Troubleshooting the Cruise Control" by Oliver Scholz.
It says that all cruises use a external module are the same except the '87~'88 4-cyl.
What it does not say is...Are the 4-cyl and the 6-cyl modules the same?
I think I need a Module for my '88 V-6. Is it the same as the same module as the 4 cyl?
-
I believe the 87 & 88 4 cylinders run through the ECM.
-
I may have found the problem...
Does anybody have a cable that connects the cruise to the throttle?
-
Yep!
-
I went to U-Pull It and found the clips... installed the cable,still no good.
Dug up the cruise control papers I bought from Rodney and went through the trouble shooting guide.
It might be the Servo...
Does anybody have a servo I can borrow to see if that is the problem?
-
Yep!
-
Charles...Your a man of many words!
-
Yep...he is ;D
-
Got it fixed.
Charles had a extra vacuum purge silenoid.
Thanks to Charles..
For future reference all cruise control parts are interchangeable...
Purge silenoid, diaphragm silenoid, control stock & control module.
I swapped all parts back and forth till I found the bad part.
After all this I know about all there is to know about the cruise control.
If anybody has any question about the cruise control let me know and I will help the best I can....
-
I believe the control module is different on the '84, and suspect the '87-'88 4-cyl is different, also.