Started digital cruise upgrade. any wiring advice?

[scottb]

I wound up taking out the b pillar trim and the center console. Will tie into the 3rd brake light wire behind the b pillar, and will run it under the carpet and out a new hole behind the center console. Hopefully will finish that tomorrow and start reassembling the rest of the car. Should be ready for testing next week. Wish me luck.

Thanks, Scott

[scottb]

So which point on the throttle body does the cruise control cable get attached to? The top with the throttle cable or the bottom one?

Hey Sarge, I sent a picture of my throttle body to your phone, let me know if that answers your question

[scottb]

wiring is now complete, I have to put the rest of the car back together which will happen this week. Stay tuned for further testing

[scottb]

and the first test drive was........ unsuccessful. I did not have any time to do some trouble shooting, I might be able to get to that tomorrow

[scottb]

Shoot me an email @rnrockinroger@gmail.com and I'll send you some info that has long since been deleted.

done

[scottb]

only trouble shooting that I could do by myself was to determine that I do have +12V at the connector.

[GTRS Fiero]

Scott and Ron, did you guys get your cruise working?

[scottb]

I  have not, havent had the opportunity to troubleshoot yet. I believe Ron has his going. Im pretty sure his car is now a 3.4 with 7730 ecm.

[GTRS Fiero]

Wiring advice?  Sure.  Cut the wires the correct length, or a bit long.  Avoid unnecessary splices.  Wire the module to the stock location on the trunk wall--not on the firewall.

Most importantly, start off with a working module.

What cable did you use, from the module to the throttle body?  Supposedly, there is one that fits, without mods.

[GTRS Fiero]

Not as of yet, but Im plugging away at it as I would really like it to work. I have power to all the wires when Im supposed to have it, so the problem must be with the cable. Unless Im really out in left field which could be true also.

Ron, did you get your cruise working?