Todd, let's see if we can do a little troubleshooting.
First, look underneath the dash at the clutch pedal. Is the master cylinder pushrod still attached?
If no, reattach it with the curl of the pushrod oriented upward.
If yes, while you're under there, pull the carpet and padding back from around where the pushrod passes through the bulkhead. Is there fluid in there?
If yes, the master cylinder needs replaced.
If no, proceed to the next step.
In the engine bay, is the slave cylinder pushrod still inserted into the clutch release lever?
If no, reinsert it.
If yes, while you're there, slide the dust boot off the end of the slave cylinder and check for fluid in the dust boot.
If yes, the slave cylinder needs to be replaced.
If no, the system may have air in it and needs to be bled.
After performing these checks, report back here of what you find and we'll proceed.