Home
About Us
Calendar
Fiero Documents
Merchandise
Tips
Links
Members
Message Board
Other Fiero Clubs
VIN Decoder
Speed Calculator
GFC Facebook Page
 

Author Topic: Bucking/Engine problem  (Read 16434 times)

0 Members and 1 Guest are viewing this topic.

lux

  • Guest
Bucking/Engine problem
« on: March 31, 2009, 01:51:25 am »
87 fiero gt

My car does this weird bucking problem when I'm at idle.
I cleaned out most of my car including the EGR valve.
I replaced a ^%!) load of things already that could have
been the problem but it continues. (I replaced plugs,
map and throttle position sensor, fuel and air filter,
dist module, and rotor.) What the hell am I missing?  ???

Fierofool

  • Global Moderator
  • *****
  • Posts: 10,589
    • View Profile
    • Georgia Fiero Club
Re: Bucking/Engine problem
« Reply #1 on: March 31, 2009, 07:08:46 am »
First, I'd like to welcome you to our forum.

I would guess that you don't notice this at road speed.  Taking into consideration the things you've already replaced, I would look at 3 areas. 

Check out the plug wires to be sure they are in the right order, and that they are in good condition.  Occasionally a plug wire will chafe or burn on the front side of the engine, where you can't see it.  You can determine which cylinder is missing by removing each wire in sequence, from the distributor cap.  It could even be that plug wires might be crossed.  I have experienced the same problem you have, and found I had swapped 2 wires.

The other possibility is that you may have a clogged or malfunctioning fuel injector. 

There are three kinds of men:

1.    The ones that learn by reading.
2.    The few who learn by observation.
3.    The rest of them have to pee on the electric fence and find out for themselves.    Will Rogers

RobsFieros

  • Hero Member
  • *****
  • Posts: 896
    • View Profile
    • East Tennessee Fiero Club
Re: Bucking/Engine problem
« Reply #2 on: March 31, 2009, 08:16:49 am »
Did you check your timing?
Robert Finley
President-East Tennessee Fiero Club
Member- Georgia Fiero Club
RobsFieros58@comcast.net

Tha Driver

  • Hero Member
  • *****
  • Posts: 601
    • View Profile
    • Angel On Earth
Re: Bucking/Engine problem
« Reply #3 on: March 31, 2009, 02:06:59 pm »
I read somewhere that a bad tach filter can cause this problem. Is your tach jumpy?
~ Paul
aka "Tha Driver"

The United States is the only industrialized nation to *outlaw* hemp production.

watkins23xl

  • Newbie
  • *
  • Posts: 8
    • View Profile
Re: Bucking/Engine problem
« Reply #4 on: April 02, 2009, 09:17:14 pm »
Ok, are you talking about when you are powering, then let off on the gas , and just between powering and giving the gas, it does it!?  If so, then check your vacuum lines.  Had the same problem in three of mine! Yup, same thing in all three.  cheneyc@bellsouth.net if this fits the problem, kind of, and I will explain it further.  If this is not your problem, then just delete! Lol ::) :o ;D :-\
Take care,
C
Actually, on my first one, the line was crimped