Home
About Us
Calendar
Fiero Documents
Merchandise
Tips
Links
Members
Message Board
Other Fiero Clubs
VIN Decoder
Speed Calculator
GFC Facebook Page
 

Author Topic: how do i release the firewall engine harnesses?  (Read 14794 times)

0 Members and 1 Guest are viewing this topic.

f85gtron

  • Hero Member
  • *****
  • Posts: 1,353
    • View Profile
how do i release the firewall engine harnesses?
« on: November 26, 2014, 05:48:35 pm »
What kind of trickery is holding the firewall engine harness to the socket?  I don't want to man handle the 30year old plastic and i can't seem to figure out how to release the thingy-whopper locking it in!
Any tricks and tips would be much appreciated!
Ron
85 GT manual NOW powered by 7730
3.4 bored to 3.5, cammed out and DIS'd
F23 connecting power to ground
My wife won't ride in it. It's "the other woman" ;)

TopNotch

  • The Duke of URL
  • Global Moderator
  • *****
  • Posts: 3,977
    • View Profile
Re: how do i release the firewall engine harnesses?
« Reply #1 on: November 26, 2014, 06:19:46 pm »
There's a little plastic clip which can be slid towards the passenger side (I think), and once that is done, the harness can be fed into the engine compartment. Remove the ALDL connector, the connector on the ECM, and whatever else is connected under the center console, and feed it all though the hole into the engine compartment.
The more complex the mind, the greater the need for the simplicity of play.