Home
About Us
Calendar
Fiero Documents
Merchandise
Tips
Links
Members
Message Board
Other Fiero Clubs
VIN Decoder
Speed Calculator
GFC Facebook Page
 

Author Topic: West coast Tach board install  (Read 13797 times)

0 Members and 1 Guest are viewing this topic.

Wreck It Ralph

  • Hero Member
  • *****
  • Posts: 932
  • Wreck it Ralph
    • View Profile
West coast Tach board install
« on: November 23, 2020, 07:57:37 am »
So I put back together my center console and what better time to rip something else apart. 😂 I pulled the gauge cluster to check out the lights and tach. I bought a new tach board from West Coast. First photo is the original then the new one. It has a pot to fine tune it but came tuned for an 88 4cyl. Also has a diagnostic led... since all but 3 bulbs were blown I didn’t finish reinstalling it last night.
1988 Fiero Base 4cyl 5spd.
1986 Fiero GT ... Parting out. Let me know if you need something.

GTRS Fiero

  • Hero Member
  • *****
  • Posts: 12,510
  • It is what it is.
    • View Profile
Re: West coast Tach board install
« Reply #1 on: November 23, 2020, 05:58:59 pm »
Did I miss seeing the original board?

Wreck It Ralph

  • Hero Member
  • *****
  • Posts: 932
  • Wreck it Ralph
    • View Profile
Re: West coast Tach board install
« Reply #2 on: November 23, 2020, 07:11:38 pm »
First photo
1988 Fiero Base 4cyl 5spd.
1986 Fiero GT ... Parting out. Let me know if you need something.

GTRS Fiero

  • Hero Member
  • *****
  • Posts: 12,510
  • It is what it is.
    • View Profile
Re: West coast Tach board install
« Reply #3 on: November 23, 2020, 07:14:02 pm »
Ah.  That is the old board.  I was expecting to see both in the same pic.

Interested in how you like the new board.

Wreck It Ralph

  • Hero Member
  • *****
  • Posts: 932
  • Wreck it Ralph
    • View Profile
Re: West coast Tach board install
« Reply #4 on: November 23, 2020, 07:17:57 pm »
Note for future photos.
1988 Fiero Base 4cyl 5spd.
1986 Fiero GT ... Parting out. Let me know if you need something.